Scanning an image for Mark Detection setup

Kodak Capture Pro Software allows you to capture and save the status of a mark area or a group of mark areas.

To use Mark Detection:

  • Scan an image containing the mark areas into Capture Pro Software.

  • Draw and select the mark detection zones.

  • Setup optional groups of mark detection zones.

Kodak Capture Pro Software allows you to scan mark detection images directly into the Mark Detection window for viewing, defining and editing.

  1. Select File > Job Setup. The Job Setup dialog box will be displayed.

  2. Select a job setup from the Job Name drop-down list.

  3. Open the Capture tab and select Bar Code, OCR and Mark Detection. The Mark Detection window will be displayed.

  4. Select the green Start/Scan button. The Scan Image dialog box will be displayed.

  5. Position the original document in the feeder and click Start/Scan. The image will be displayed in the dialog box. Scan the image as straight as possible. Your scanner will use the parameters of the current Capture Pro Software page setup.

  6. Click OK to save the image.

 

  • Any auto-rotation, auto-cropping and deskew settings from the current setup will be applied to the scanned image before it is displayed.

  • If the image is acceptable, enter a name in the Image name field. The image name should not contain any of the following characters:  : “  ?  .  <  >  \  /.

  • To discard the image, click Cancel.

  • Before you can define a mark detection zone, you must have at least one image in the Image drop-down list.

  • You can also transfer an image from the Image Viewer to the Mark Detection window.

See also:

Transferring an_image_to_the_Mark_Detection_window