Sort - by Bar Code

In the left pane of the Capture tab, choose Sort By Bar Code. The sorting rules define how to handle pages with bar codes. The dialog you see will vary, depending on whether you are connected to a scanner that does physical sorting (e.g. the Kodak i5x50S).

If your scanner will do physical sorting:

Choose Sort by bar code type. The TWAIN driver UI will display, enabling you to set up bar code sorting rules.

If you add bar code rule(s) and select OK in the TWAIN dialog, then Sort by bar code type will remain enabled, and the text next to the Settings button will say (Settings are configured). If you do not save a bar code rule in the TWAIN dialog, then the Off radio button will be selected automatically, since nothing was configured. The Settings button is enabled only when one or more bar code sorting rules have been saved. Use the Settings button to re-enter the TWAIN driver bar code sort tab.

Bar code sorting that you set up in the TWAIN UI will be stored in the Job Setup definition for your scanner type.

If your scanner will not do physical sorting:

Choose Sort by Bar Code Zone if to set up manual sorting rules based on one or more predefined bar code zones. Select Add to configure bar code sorting rules. The rules are saved in the Job Setup definition for non-sorting scanners. On this screen, each row of the table shows which bar code zone the rule is applied to, the sorting condition, and the message that will be displayed.

Add — Open the Add bar code zone dialog box.

Edit — Open selected rule for editing in the Add bar code zone dialog box.

Delete — Remove the selected rule.

Move Up / Move Down — Move the selected rule up or down in the list. The first rule that is met will be applied.

For all scanners, during Scanning: When Sort by Bar Code is enabled and a bar code rule is detected by the scanner:

For scanners that support physical sorting, the page will go to the Destination tray defined for physical sorting and scanning will continue.
For manual sorting and Destination is Pause and Continue, scanning will stop, the configured message will display for the specified number of seconds and close, then scanning will resume.
For manual sorting and Destination is Stop, scanning will stop and the configured message will display. Button options will be Continue scanning or Stop.