Recovering from a paper jam

You can restart the scanner after a paper jam using a software command.

To recover from a paper jam:

1. Clear any paper from the scanner.

2. Make sure all of the scanner’s access doors are completely closed.

3. Wait until the scanner is ready. Check the Image Viewer to verify the last complete image you received from the scanner before the paper jam. Restart scanning from that point.

4. Select Capture>Start. The scanner should start scanning again.

For information on restarting the Kodak i200 Series Scanners, click hereThe red indicator light remains on until the scanner is restarted. If the jam was properly cleared, the red indicator light will go out and the green indicator light will illuminate..

See also:

Starting the scanner within the software

Stopping the scanner within the software