Settings - opens the Scanner Properties dialog box for your scanner, which allows you change the scanning parameters.  For more specific scanner information, go to the User Guide for your scanner.

Display settings prior to scanning - enabling this checkbox opens the Scanner Properties dialog box after you click the green Start icon.

Flatbed delay - sets a timed delay between scans so that the operator can open a different page on a book or magazine and place it back on the flatbed.  Select the number of seconds for the delay from the drop-down list.

Software rotation - automatically rotates the image after scanning.  Select None, 90, 180, or 270 degreesettings.  As you enter a different setting, the icon will display how the image would look after rotation.

Setting up this rotation in the TWAIN Datasource may give you better scanning performance than using Software rotation.

2-sided mode - select Classic mode or Calendar mode in the drop-down list for two-sided scanning and the corresponding icon will be displayed. Compare your original image with the icon to determine if it has a classic or calendar layout.

Classic - typically used for multi-page reports.For more information, click hereThe two-sided scanning option mode only influences the way the front image is rotated in relation with the back image. It does not set the overall rotation of the document
(0° , 90° , 180° , or 270° ).

When using the Classic two-sided scanning mode, the front and rear images correspond as follows:

A 0° rotated front results in a 0° rotated back.
A 180° rotated front results in a 180° rotated back.
A 90° rotated front results in a 270° rotated back.
A 270° rotated front results in a 90° rotated back..

Calendar - typically used for presentation handouts, financial reports, wall calendars, etc. For more information, click hereThe two-sided copying option mode only influences the way the front image is rotated in relation with the back image. It does not set the overall rotation of the document
(0° , 90° , 180° , or 270° ).

When using the Calendar two-sided scanning mode, the front and rear images correspond as follows:.

Image order - select an image and use Move Up or Move Down to change the image order listed in the box.

Overcrop - enable the checkbox to trim all edges of the image by the amount specified in 1/100ths of an inch.