Test Image dialog box

Use this box to test your images to determine whether or not they meet your deletion settings. It is highly recommended that you test your settings to be sure that the images you want to be deleted are deleted and that you keep the images you want to keep.

Start scan: starts scanning the test imageThe scanner converts sides to images. Every image belongs to a document with a unique document number. The software gives every image a sequential number inside its document. One document can contain up to 999999999 images. The software distinguishes between an image coming from the front or rear side of a page. This allows the software to perform side-specific processing (e.g., deletion of blank/rear sides) where appropriate. The software also distinguishes between color, grayscale, and black and white images and can perform color/grayscale versus black and white specific processing. Example: Document 250 contains two double-sided pages and produces an electronic document number 250, which contains four images (1-4)..

Stop scan: stops scanning the test image.

Test Image: After you scan a pageA page is always in paper form and is part of a paper document. A page can produce one image (single-sided page), two images (double-sided page), or four images (both color and black and white) after scanning., select Black and White Front, Black and White Back, Color-Front, or Color-Back from the drop-down list.

The options that are displayed in the drop-down box are dependent upon your Page Setup.

Under Test Result, the following information appears for each of the four Test Image options:

The image is - indicates if image is Blank or Not Blank.
Image size is - (bytes) - the size of the test image in bytes.
Content is - % - the percentage of content in the test image.

OK - closes the dialog box. Your image has been tested.

During "test image" scan, options to Split and Merge will be ignored.

To return to the Job Setup dialog box, click here.